I'm looking for troubleshooting suggestions for a Aquarite Goldline generator system. I have no display or lights and know the following:
- I replaced the main circuit board because the Hayward folks told me this was the most likely fix if the fuse was good. So I have a new board with fuse installed.
- This system has no external fuse, so uses the fuse on the board.
- I have power to the main circuit board.
Any thoughts on what to do to isolate the issue? I don't perceive there to be but 2 other components: 1) the small circuit board with the display on it and 2) the transformer. But I don't know how to determine if one or the other of these is at fault. Are any other possibilities?
One final note. This system is "out in the country", so I have limited access to it - 1/2-day round-trip travel time.
- I replaced the main circuit board because the Hayward folks told me this was the most likely fix if the fuse was good. So I have a new board with fuse installed.
- This system has no external fuse, so uses the fuse on the board.
- I have power to the main circuit board.
Any thoughts on what to do to isolate the issue? I don't perceive there to be but 2 other components: 1) the small circuit board with the display on it and 2) the transformer. But I don't know how to determine if one or the other of these is at fault. Are any other possibilities?
One final note. This system is "out in the country", so I have limited access to it - 1/2-day round-trip travel time.