I had the pool built in June.
Everything was brand new. The Pentair Intellichlor recently started reading the flow as low (red light) so I opened up the filter system and cleaned out the cartridges real well, including using a shop vac to clean out any excess water. Put everything back together and it seemed to run fine.
However, it still reads low flow.
The problem is, if I put the speed at the 3rd setting (2350) it's fine and flow light goes green, water fills up in the filter and everything is fine. Whenever I go back down to the 2nd setting (1600) the water empties out of the filter and it goes to red again.
Am I doing something wrong? Is there something else I should be cleaning?
Thanks for any info. I have nobody to ask questions as the guy that sold me the pool isn't available.
Everything was brand new. The Pentair Intellichlor recently started reading the flow as low (red light) so I opened up the filter system and cleaned out the cartridges real well, including using a shop vac to clean out any excess water. Put everything back together and it seemed to run fine.
However, it still reads low flow.
The problem is, if I put the speed at the 3rd setting (2350) it's fine and flow light goes green, water fills up in the filter and everything is fine. Whenever I go back down to the 2nd setting (1600) the water empties out of the filter and it goes to red again.
Am I doing something wrong? Is there something else I should be cleaning?
Thanks for any info. I have nobody to ask questions as the guy that sold me the pool isn't available.