Tested the pool with my new TF-100 test kit.
Salt is 3200ppm
FC 2.0
PH 8.2 (high as it can measure)
CC 0
TA 70
CH 540 (Whoa 2nd Year for the plaster pool maybe?)
CYA The dot was still there at full tube.
Temp 85 - Normal for here. Heat pump is not on.
I am having some small (less than dime sized) algae spots on the pool surface. I have cleaned the SWG.
I have a problem with high PH all the time. I have to add acid (muriatic) almost daily to keep the PH down.
I need to shock the pool (bleach) but I also need to add CYA to get a reading. Should I add stabilizer first then shock?
Any suggestions???
Thanks
Salt is 3200ppm
FC 2.0
PH 8.2 (high as it can measure)
CC 0
TA 70
CH 540 (Whoa 2nd Year for the plaster pool maybe?)
CYA The dot was still there at full tube.
Temp 85 - Normal for here. Heat pump is not on.
I am having some small (less than dime sized) algae spots on the pool surface. I have cleaned the SWG.
I have a problem with high PH all the time. I have to add acid (muriatic) almost daily to keep the PH down.
I need to shock the pool (bleach) but I also need to add CYA to get a reading. Should I add stabilizer first then shock?
Any suggestions???
Thanks