Hi there,
I have been using this site for 5 years now and have always been successful with finding the info I needed in order to fix my problem. This time I need some extra help if anyone would be kind enough to share your input.
I replaced my salt cell (T-15) Hayward / Aquarite - I checked installation and my wiring etc. and all seems to be in order.
My check system light is on and despite adding a lot of salt my reading is still saying very low salt and stuck at 2200 ppm.
The system is saying NO FLOW and Chlorinator is off despite being set at 95% and super chlorinate activated - It is as if my system is not recognizing the new cell was installed. The software version is 2.6 so from what I read it sounded like I did not need to reconfigure anything.
I have gold line controls - and we have a spillover / spa feature
Water has been tested and balanced although I suspect we might have a high salt level now but can't be sure.
Does anyone have suggestions?
I have been using this site for 5 years now and have always been successful with finding the info I needed in order to fix my problem. This time I need some extra help if anyone would be kind enough to share your input.
I replaced my salt cell (T-15) Hayward / Aquarite - I checked installation and my wiring etc. and all seems to be in order.
My check system light is on and despite adding a lot of salt my reading is still saying very low salt and stuck at 2200 ppm.
The system is saying NO FLOW and Chlorinator is off despite being set at 95% and super chlorinate activated - It is as if my system is not recognizing the new cell was installed. The software version is 2.6 so from what I read it sounded like I did not need to reconfigure anything.
I have gold line controls - and we have a spillover / spa feature
Water has been tested and balanced although I suspect we might have a high salt level now but can't be sure.
Does anyone have suggestions?