- May 2, 2008
- 43
I noticed last week that the pressure gauge on my sand filter has water and condensation in it. This is the first time that it has happened since I installed the sand filter back in December. If I remember correctly it happened shortly after a backwash/rinse cycle.
I left it alone for a week to see if it would dry out on its own but there has been no changes.
Is there a leak somewhere causing this or should I just disconnect it and let it dry out between filter cycles and not worry about it?
I left it alone for a week to see if it would dry out on its own but there has been no changes.
Is there a leak somewhere causing this or should I just disconnect it and let it dry out between filter cycles and not worry about it?