I noticed my Chlorinator led lights weren’t operating. Checked the cell and it seems to be dead. When I opened the EZ touch I noticed the black wire connector to the circuit board was burned. I obviously need to replace the wire, but is there additional problems I should look for so I don’t hook this new wire up and have the same problem?
In addition, my mobile automation is acting strange. If the filter is running (scheduled daily time), I can activate lights, waterfall feature....but if the system is off, I can’t turn anything on...including pump and/or spa. Seems strange that both issues would be independent at the same time. Could these issues be connected or is it just a bad coincidence?
Thank you all in advance.
In addition, my mobile automation is acting strange. If the filter is running (scheduled daily time), I can activate lights, waterfall feature....but if the system is off, I can’t turn anything on...including pump and/or spa. Seems strange that both issues would be independent at the same time. Could these issues be connected or is it just a bad coincidence?
Thank you all in advance.