pool out of plumb

Theone01

Member
Jul 1, 2018
11
Haverhill,ma
So our pool sank. the sides of the oval are out of plumb. Found out installer put in patio block under them.

since that happened the top inside rail has also stretched at the top in a few places

pics below

any advice????
 

Attachments

  • pool.jpg
    pool.jpg
    59.2 KB · Views: 235
  • side wall.jpg
    side wall.jpg
    46.8 KB · Views: 233
  • liner.jpg
    liner.jpg
    28.9 KB · Views: 229
What brand of pool do you have? Have you seen any the installation instructions?

Our Doughboy instructions require cinder blocks under the side uprights due to metal pressure pads under those uprights. The rest of the uprights use 12"x12"x2" patio blocks. Also the spot under the patio block must be dug out to the correct depth. The ground must be level and undisturbed under where those blocks are placed. They cannot be backfilled with dirt if dug too deep. If backfilled, they could settle.

Hope this helps.
:snorkle:
 
Hopefully your installer put the cinder blocks in the right way as they are only structural in one direction. Meaning they would have had to solid fill them or put something top and bottom
 
Thread Status
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.