Hi,
New to the forums and searched around a bit but couldn't find an answer so apologies if this has been covered before.
Recently had a "Brown out" with my electric supply and it blew the thermistor on the PCB, i have had this problem before so got a new one soldered back on place of the old one.
Problem i have now is that the power light is on but the "Check Salt" and "Inspect Cell" lights are on and i cannot get a salt reading on the display (PPM) or reset it by holding down the diagnostics button, i swapped a unit i had from another house to check the cell and everything worked just fine, wondering what to do next.
New to the forums and searched around a bit but couldn't find an answer so apologies if this has been covered before.
Recently had a "Brown out" with my electric supply and it blew the thermistor on the PCB, i have had this problem before so got a new one soldered back on place of the old one.
Problem i have now is that the power light is on but the "Check Salt" and "Inspect Cell" lights are on and i cannot get a salt reading on the display (PPM) or reset it by holding down the diagnostics button, i swapped a unit i had from another house to check the cell and everything worked just fine, wondering what to do next.