new easytouch IC60setup

[wbrewski]

I do not know if I have problem or not. Here is what is going on, I set my easytouch controller for 50% output. on the IC60 all the lights are on ( % lights) and some times the last 2 go on and off. all other lights says everything is ok , flow, salt level all green.
Has anyone had this happen?

 

[Jimrahbe]

w,

I have not seen that issue and don't believe it is normal.. If installed by your pool builder, I'd have them come look at it. If installed by you, I'd call Pentair.

Thanks,

Jim R.

 

[wbrewski]

Pentair was no help at all, a bunch of kids with no trouble shooting skills, I found my problem, in the transformer for the IC 60 the little circuit board was bad. I replaced the board and now it works perfect.

 

[Jimrahbe]

Walt,

Thanks for the feedback as it could help others...

Just curious... Since this was new unit, did Pentair provide you with a new board, or did you have to buy your own? If you had to get your own, where did you buy it?

Thanks again for the follow up,

Jim R.