I got a email notification this morning via my AquaPlus Automation saying my PH was high which surprised me as it usually never budges form 7.5. Pull it up on my phone via AquaConnect and it's reading PH at 8.3! I immediately go out to my equipment pad and the Stenner pump is cycling acid continually, so I get my TF-100 out and run a PH test and it's reading 7.0 now that the Stenner had been pumping acid. I ended up doing a calibration on the probe based off my reading and all seems inline again so I started the aerating process to bring it back to 7.5. If I didn't have a good kit to calibrate with I can't imagine how much more acid would have been added and how low my PH would have been. I'll be keeping a eye on this, perhaps the probe needs a cleaning if it goes out again. Anyone else have this happen before?
Salty
Salty