I have an Intermatic X100 currently that goes to my pool light and controlled by a RC613 but when we bought the house the remote had been lost and it's in a very inconvenient location. I found a GoControl zwave switch GoControl Z-Wave Isolated Contact Fixture Module - FS20Z-1 GoControl Z-Wave Isolated Contact Fixture Module - FS20Z-1 - Connected Home Modules - Amazon.com Is there a how to out there how to wire this in? I read and re-read directions but just want to confirm I do it correctly. TIA
Wiring a Z Wave Switch to Intermatic X100
- Thread starter athflying
- Start date
Greetings and welcome.
Sorry i cant help you directly, but just so you know, when it comes to specific combo automation integration questions like this, you might also have luck with a zwave-Intermatic question over at Pool equipment - Connected Things - SmartThings Community
With that said, there's always a chance someone will come along here whose had that experience.
Sorry i cant help you directly, but just so you know, when it comes to specific combo automation integration questions like this, you might also have luck with a zwave-Intermatic question over at Pool equipment - Connected Things - SmartThings Community
With that said, there's always a chance someone will come along here whose had that experience.
Black to hot input, white to neutral. The two blue wires go to the load (your light). Green is obviously ground. What Hub are you using to control it?
Wink...thanks. That's what I thought from instructions but with all things electrical I like to check 3 times before doing anything.