- Mar 4, 2011
- 313
- Pool Size
- 22600
- Surface
- Vinyl
- Chlorine
- Salt Water Generator
- SWG Type
- Hayward Aqua Rite (T-15)
I have gone through the TFP process before and am sort of excited to do it again - is that weird?
My pump went out during Hurricane Matthew in October, so my water has sat since that time - enough said.
New pump, SWG flow switch, and refreshed T-100 reagents and I am ready to go. My numbers from today are posted below. This is after allowing the pool to circulate for 24 hours. I will be using the pool calculator to get info, but where should I start? pH? Thanks in advance! I will be sure to keep pics posted along the way!!
FC = 0
CC = 0 (I tested this more than once as I know it cannot be true. Is pH throwing it off? Something else?)
pH = 8.2+ (bright pink)
TA = 70
CH = 25
CYA = 0 (tested twice, never lost sight of the dot; I did have to use a sump pump to drain quite a bit of water after the hurricane and ended up putting some back in there recently)
My pump went out during Hurricane Matthew in October, so my water has sat since that time - enough said.
New pump, SWG flow switch, and refreshed T-100 reagents and I am ready to go. My numbers from today are posted below. This is after allowing the pool to circulate for 24 hours. I will be using the pool calculator to get info, but where should I start? pH? Thanks in advance! I will be sure to keep pics posted along the way!!
FC = 0
CC = 0 (I tested this more than once as I know it cannot be true. Is pH throwing it off? Something else?)
pH = 8.2+ (bright pink)
TA = 70
CH = 25
CYA = 0 (tested twice, never lost sight of the dot; I did have to use a sump pump to drain quite a bit of water after the hurricane and ended up putting some back in there recently)