I just installed a new Hayward Ecostar 3400VSP pump. All went fine except now I have a timer on/off issue. Prior to this i had a single speed pump which was turned on/off using an Intermatic timer. This was set up by the pool builder so the pump, SWG, and heater were all turned on by this timer. Now that my new pump has the timers built into it, I need to set those up and use them. So I have the Intermatic timer "off"(on/off tabs taken off) so that the pump is getting power 24 hours a day. Problem with that is now the heater and SWG are powered on 24 hours day. The Hayward heater now runs all the time, (heater isnt on but the blower motor runs), and the SWG is on, but since it doesn't have any water flow it generates an error. I need to figure out how to run the pump using the internal timer, but have the heater and SWG on only when the pump is running. How will I accomplish that?