Got on issue with my pool heater. When the command is sent to start I can hear the ignitor clicking away but it does not "fire" up like normal. After awhile it will go BOOM igniting all the gas from start. Any ideas?
Major cleaning effort did the job. Ignition and pilot light works like a charm. I even pulled off the exhaust vent and top then cleaned the copper tubes above the burner which had some major green corrosion and rusty metal pieces. I cleaned all the connections. The pilot light and ignition is buried underneath the unit so it took a little inginuity to get a steel brush that deep. I wanted to do as much as I could before pulling out the burner if that did not solve the issue. All good so far.
Hello , This thread has been inactive for over 60 days. New postings here are unlikely to be seen or responded to by other members. For better visibility, consider Starting A New Thread.
Welcome to TFP! For a wealth of pool care information please check out our free Pool School. If you are in need of specific help then we encourage you to Register and ask us here in the forum!