Although my liner on the box/label says it is correct for a 52" 27' pool, the liner just doesn't seem to fit right. It is a Jbead, and I installed it on a sunny day, the liner was nice and warm/plyable. I just can't seem to get it to sit flush with the wall all the way around. top photo shows where it seems to pull away from the wall the worst, second it gets better, then 3rd its pretty much on the wall. The pool is in round. It really doesn't make sense (to me) why it is doing this, or if it is normal. I am new to this and the instructions gave now troubleshooting tip or mentions of this situtation. If I were to guestimate, I'd suspect the liner is about 6" away from where the cove meets the floor in the most extreme spot (1st photo)
Any advice, before I start putting water to this and risk buckling the walls would be appreciated! Thanks
Any advice, before I start putting water to this and risk buckling the walls would be appreciated! Thanks