I have a Hayward H250 heater that I installed last year. It replaced the exact same unit. I stripped some parts from the old unit including the High Wind Vent system. I did not reinstall this into the new heater at the time, but am now finding out that the pilot keeps blowing out and is a bit of a pain because the pool is not getting heated when I want it to. For the life of me, I can't figure out how to remove the top panel of the heater to install the venting system. I remember it being a breeze to disassemble last year from the old unit. If I read the manual for the heater, it mentions the use of the same HWS vent that I have and says to refer to the manual in the box for the HWS for installation instructions. So I went to Hayward and they refuse to help me stating I need to get a registered gas contractor to install the vent. I know this is a fairly simple process, but need to get the small vent door removed first.
Does anyone have any experience with installing one of these?
Thank you,
Jup
Does anyone have any experience with installing one of these?
Thank you,
Jup