Also read the Water Balance for SWGs and it suggested the following levels:
FC 4-6 ppm (currently too low, @ 3.5)
PH 7.5-7.8 (currently too high, @ +8)
TA 60-80 (currently now too high, @ 90)
CH
SLAM says to lower PH to 7.2 though. is that correct?
- - - Updated - - -
In addition should I bring my CYA up to 60 before slamming as it is very low and may not be being read correctly because of this
FC 4-6 ppm (currently too low, @ 3.5)
PH 7.5-7.8 (currently too high, @ +8)
TA 60-80 (currently now too high, @ 90)
CH
- 220-320 for fiberglass (currently much lower, @ 80)
- CYA 70-80 (currently much lower, possibly below 30)
- Salt 200-400 ppm ABOVE recommended optimum level (currently correct @ 200+)
- Borates 30-50 ppm (optional)(none)
SLAM says to lower PH to 7.2 though. is that correct?
- - - Updated - - -
In addition should I bring my CYA up to 60 before slamming as it is very low and may not be being read correctly because of this