So this summer I had to buy a new pump b/c my hayward (15 yrs old) died.
I went with the Pentair VST 2 and the idea of automation seemed cool. I am already all into home automation with tons of Z-wave stuff. I was disappointed there is little in the way of z-wave, but i have never been able to get a z-wave signal to relay far enough to my pump anyway to use the intermec Z-wave device I bought 2 yrs ago.
Anyway, back to my point:
Does anyone here use pentair's automation, ez touch or otherwise and if so, would love to understand your setup and then ask you a million questions. The store reps and even the pentair reps are a bit 'short' both in attention and in IT knowledge to correctly answer my questions.
I went with the Pentair VST 2 and the idea of automation seemed cool. I am already all into home automation with tons of Z-wave stuff. I was disappointed there is little in the way of z-wave, but i have never been able to get a z-wave signal to relay far enough to my pump anyway to use the intermec Z-wave device I bought 2 yrs ago.
Anyway, back to my point:
Does anyone here use pentair's automation, ez touch or otherwise and if so, would love to understand your setup and then ask you a million questions. The store reps and even the pentair reps are a bit 'short' both in attention and in IT knowledge to correctly answer my questions.