Before I replace this thing I figured I'd ask the experts here at TFP. Pentair was very little help given the cruddy 1 Year Warranty.
My cell has been working great since it was installed in October of 2013 until this weekend. Now, the only light that is lit is the salt light which is red. I've checked my salt multiple times, and it's around 3800ppm - so that's obviously not an issue. Usually when it starts up, it flashes green/red for a couple minutes, but it doesn't do that anymore either. The salt light goes on/off when I turn on/off my pump, but that's it. I've tried cutting all the power to the system (via the circuit breakers), and I've checked to make sure everything is good in the power center (light is on, fuse is fine, etc.). I've also checked the wires that run from the cell to the flow sensor which are all fine too.
Can you guys think of anything else I could try to get this thing working again before I just spend the $600 to get a new one?
Thanks in advance!
My cell has been working great since it was installed in October of 2013 until this weekend. Now, the only light that is lit is the salt light which is red. I've checked my salt multiple times, and it's around 3800ppm - so that's obviously not an issue. Usually when it starts up, it flashes green/red for a couple minutes, but it doesn't do that anymore either. The salt light goes on/off when I turn on/off my pump, but that's it. I've tried cutting all the power to the system (via the circuit breakers), and I've checked to make sure everything is good in the power center (light is on, fuse is fine, etc.). I've also checked the wires that run from the cell to the flow sensor which are all fine too.
Can you guys think of anything else I could try to get this thing working again before I just spend the $600 to get a new one?
Thanks in advance!