Plaster crew finished yesterday afternoon , diamond brite bahama breeze was used
pool is now filling , and since my builder has pretty much ditched me , I am on my own.
Plasterers added sequestrant (4 bottles of startup tec)
I have several questions , I'm assuming the acid startup is the way to go ?
on the plaster startup page it says , do not run pump at first , how long before I turn it on after adding muratic?
after I initially add MA , do I then start pump , and start brushing ? But add nothing else until most of the dust has cleared ? Even if this takes a week , or two ?
So sorry for sounding like a dummy , but am just a little freaked out and overwhelmed. This pool build has almost broken me down , and have had to learn and stress a whole lot over the last few weeks.
at what point should I start adding other chemicals , suggestions greatly appreciated.
pool is now filling , and since my builder has pretty much ditched me , I am on my own.
Plasterers added sequestrant (4 bottles of startup tec)
I have several questions , I'm assuming the acid startup is the way to go ?
on the plaster startup page it says , do not run pump at first , how long before I turn it on after adding muratic?
after I initially add MA , do I then start pump , and start brushing ? But add nothing else until most of the dust has cleared ? Even if this takes a week , or two ?
So sorry for sounding like a dummy , but am just a little freaked out and overwhelmed. This pool build has almost broken me down , and have had to learn and stress a whole lot over the last few weeks.
at what point should I start adding other chemicals , suggestions greatly appreciated.