So last year my "check system" light came on and I found out the relay solder pad had heated and melted. There were many threads to this and how to repair. I fixed this and the system ran fine at the end of last season and fine when I opened this year. About 1 month ago I noticed my chlorine dropped off when I had it set to about 50%. No system lights or any other indicators something is wrong. I shocked/ balanced CYA and increased the chlorinator 80% and a week later the chlorine dropped off again. I have done this mutliple times and superchlorinated looking some sort of life and nothing. Water is fine right now because I have been persistent with my BBB. This afternoon I took my cell to a shop to get tested and they said it was fine.
Voltage and current reading in pic.
V = 25.93
A = 6.61
Cell temp is 80F
3200 PPM which matches my salt test strip
My cell is the T15.
Any ideas, measurements, tests, suggestions...........
My next thread will probably be asking the group for what I should replace the AQL PS8 with.
Thanks in advance, Joe
Voltage and current reading in pic.
V = 25.93
A = 6.61
Cell temp is 80F
3200 PPM which matches my salt test strip
My cell is the T15.
Any ideas, measurements, tests, suggestions...........
My next thread will probably be asking the group for what I should replace the AQL PS8 with.
Thanks in advance, Joe