pentair screenlogic app

I came back from a month long trip and my screenlogic app is no longer working. I’m in FL so we often have storms and prolonged power outages. I can connect to the app but it doesn’t show temperatures and the controls can be used/turned on in the app but they aren’t turning anything on in my...

Moved into a house and inherited a pool with a pentair system. The screenlogic apps on Android and iPhone don't work on local or remote, but the desktop app works fine. Any ideas? Thanks!

Hi everyone, Need assistance in setting up a schedule for our "inground Cleaner" & "VSP Pool Pump". Question: If i setup pool pump to run 12 hours, say 8am to 8pm daily...and I have a schedule for CLEANER to run 1pm to 5pm daily, is this system smart enough to know when to run the Cleaner...

My family just had our pool built last year and our pool installation contractor recommended/sold us the Pentair system. The system seemed great because our family rents out the home during the summer and with the Pentair Screenlogic app, we can control the heat for guests from outside the home...

This is the opposite of what everyone else normally asks about how to turn off the delay. I want to create a delay (the same as the pool cleaner delay) before the heater turns on in the intellitouch/screenlogic software. After 2 years of monitoring the heater behavior (Mastertemp 400) as we...

I have a Pentair Easytouch system, The Spa light and pool lights are IntelliBright 5G. In the App on my atch, IOS Phone, and PC the lights will come on manually when I turn them on from any location. I have both lights on individual cicuits so I can control each seperately. My problem is, only...

Is there a way to create a circuit in Screenlogic that mimics the "Spa" circuit, but just has a lower pump rpm? Right now my Spa setting sets the jets to 3450 rpm and has lots of bubbles in the spa. Sometimes I'd like to keep the heat going and not have the bubbles. Ideally, I would create some...

We just had a new Pentair ScreenLogic system added to our existing pool system We can use ScreenLogic to connect remotely to the system but when trying to connect on the local network the app never gets past the ”Searching for system controller” message. Our pool guy and I have called Pentair...

Hello, I found this forum from googling about my problem, and not quite finding the answer I was looking for. I'll try to do this properly, so as not to frustrate those who want to help! I have a Pentair pool/spa that was installed somewhere around 2015/2016. We bought the house in 2018, and I...