Aquapure was working fine until a day or two ago (after a party). Filter pressure seems fine and salt levels are at about 3000. The pool and salt cell are about 2 years old. Could it be scaling on the salt cell? It doesn’t appear to be a flow issue. I believe all the indicators mean that it is...
Hey all -
Here is my issue. I just installed a new Jandy Chlorinator (PLC1400) to replace my old one that was not working anymore and pins inside were corroded. Installed the system exactly as the old one was installed. When the system is on auto (Jandy Aquilink controlled) the chlorine...
I spoke with Jandy by email they have confirmed that it is possible, BUT wont give me instructions only dealers of their products....
Our existing handheld which was on our old controller is
Handheld 3.0 Blue Jandy PDA (Blue One)
The JBox has a V3.0 sticker the board says 4606.
When both the...
I am laying out my SWCG installation and I had purchased a FLOWVIS flow meter. It is 6.5 inches long and my AquaPure 1400 SWCG is 16.5 inches long. So, I am trying to fit all of this together and will need to make a U-turn back to my existing pool return. See photo diagram.
How much...
OK.
I am pretty frustrated with my equipment (pump-swg), and I am considering starting over. I want my automation to work more smoothly, and I'd like to gain some reliability.
What I have:
Control: iAqualink 2.0 with the V2 board.
Main Pump: A centry V-green pump. I have the V-Green...
I was reading some other threads on SWG performance and there was a discussion on the maximum flow rate through a SWG should not exceed 80gpm. I think this was for Pentair or CircuPool systems.
I am about to purchase a Jandy AquaPure 1400 because it will link easily to my iAquaLink...
Hello All!
I am getting error codes 194 and 125 on my Jandy AquaPure 1400. While following the troubleshooting guide, the Cell Voltage and Cell Current tests were the only things out of spec. I am getting ~8.5V when testing the Cell connection test points (supposed to be 22 to 28) and 0 mV for...