intellivalve

I saw an old thread about this but nothing recently so figured I would ask. I have a new pool with a waterfall and bubbler controlled by the pentair intellicenter and intelllivalve. If I turn on the waterfall or bubbler independently they work just fine but if I try to turn them both on at the...

Hi, I have an Easytouch 8 system from 2008. There is a Mastertemp 400 (460737) (and a ThermoFlo heat pump) plumbed in series.. The Propane Mastertemp heater is set to heat when in Spa mode. The Mastertemp Heater is controlled using the two-wire Fireman's Switch with the wire running to the...

Hi, My Pentair intellivalve actuator is not switching to Auto mode.i shows red light and and nothing happens when I press the mode button. This is causing water overflow from the pool and not heat up properly when spa is turned on. Have any of you faced this issue and is there anything I can do...

I have the i10PS IntelliCenter system. This issue is relate to the intellivalves. On my system there are 2 ports for Intake and return valves and 2 Aux ports labeled A and B. I was renaming Aux A and I called it Intake. The system defaulted that valve to the Intake and it removed the ability to...

The week of the 6th, I have been given the opportunity to meet with several mid-level/senior management as well as coordinator types from Pentair Pool Products who are directly involved with IntelliCenter. We're going to meet up here at my home in the Phoenix area. These are folks that I have...

I think my best fix would be to remove the actuator and put a manual valve on there for the time being since it will be a couple weeks before I can get pentair out there to warranty it. Any videos/advice to remove it correctly?

Hello TFP! Please forgive me as I attempt to explain my pool situation and questions. I purchased a home last year that came with an in-ground pool, the first one I’ve ever owned. It’s been quite the learning curve. I’m a DIY’er and trying to move forward this year without the help of a pool...

So, I was pre-mounting my IntelliValves today and there is an issue. This situation could occur with any valve actuator and I'm wondering if anyone has experienced the following. So when I re-plumbed this summer, I placed the Jandy valves too close to one another. Now if I mount the actuators...