intellichem

I'm installing a Pentair Intellichem system. I have an Intermatic RC2163BFE load center. Here is the wiring diagram from the Intellichem manual. I am looking for some assistance as a complete newbie. I'm assuming I will need to wire this as 240VAC as it recommends connecting Intellichem to the...

Hello. First time poster/user. New gunite pool/spa owner. I have heard such good things about this community, looking forward to learning from each of you So i tested my water manually this week, and last week, and I am showing good ph, good orp, but fcl is low to zero. Alk is good too...

My “jelly jar” cracked due to ice. The replacement is $250 which is highway robbery. It doesn’t appear any different than the canisters I use for my water filter system and aquariums. Does anyone know an alternative to use? Tomorrow I plan to see if any of my canisters fit. Thanks!

My pool builder set my pool and spa up as 2 separate bodies of water. They both have their own filters, Mastertemps, IC40s, Pumps, ect. But they share 1 easy-touch panel. He also installed 2 intellichem systems. My pool intellichem is wired into the easytouch and the IC40 is connected to the...

Hello, My new house came with a pool (woot!) that runs the Easy Touch Intellichem system with an IntelliPh. Through the help of TFP community and many, many youtube videos I've figured out most of how to program/setup my IntelliChem system. My problem is I can not for the life of me figure...

Hi, I’m about to begin my installation of the IntelliChem and an acid tank. I’ve read numerous threads, TFP further reading on this and the install manual. The manual is ok, but the diagrams are not great especially with the latest hardware being provided. Like the new placement to the low flow...

Hello Folks. A few months ago I finished my pool and always wanting to experiment with automation, I pull the trigger on a Intellichem with CO2 system. Per recommendation on this forum I'm not using it for chlorine control but only for pH control. I'm not to concerned about the additional...

Hi Folks. I've just completed my installation which includes an Intellichem governed Intellichlor all tied up to an Intellicenter. Despite all odds so far everything is going ok. I have a question though: is there any place I can see a log of each time the cell is activated and at what...

My Pentair Intellichem had been working fine for close to a year, Now it is saying my orp is low, it is showing it at 250, and then when I go to my ORP settings, the Dosing line that is usually at the top doesn't even show up, and the middle line where it shows the gauge level just doesn't show...

Like many, I was hit with some freeze damage during the winter deep freeze in Texas. I was fortunate to have a whole home generator which saved me from more severe damage. I did not however escape unscathed. My Intellichem JellyJar cracked as did the housing and intake filter. Anyone who has...

I have an Intellicenter and an IC60 for a 40K pool. Im looking to automate the acid side using Intellichem, but also considering purchasing the extra pump for liquid chlorine as a backup to the IC60 or to quickly balance a season start or after heavy use. Does anyone know if this would work?