gfci

My first post here, I'm happy to have found this forum. I'm not exactly sure what is going on here so any help would be appreciated. I have pool lights and spa lights that trip the GFCI when the Jandy aqualink RS is in auto mode and the lights are scheduled to come on each night. The controller...

Hi - I am trying to figure out what's going on with my Dolphin, I have narrowed it down to the robot itself (I have two controllers and both experience the GFCI trip and run fine when normally when robot is disconnected). I have narrowed it down further to when the robot tries to climb the...

Hello everyone, I recently noticed that my pool lights are not turning on. I have a Pentair Automation system and PAL Evenglow lights linked via a PAL PCR-4 box. I opened the PCR-4 box and realized no power was getting to it (the wifi lights were turned off so I assumed no power was flowing to...

Hey guys! I wasn't exactly sure where to ask this, but running into an issue on my dry pool set up. The area that would be most suited for the pool is pretty far from an outlet, let alone a gfci one. Our home is older and has only one gfci outlet in the entire home. What setup do I need. I know...

Hi, I've read around the forum, but I can't seem to find a similar post, so here we go... I came home to find that my pool pump was not running. Went down to check it out and found the the Pentair 220amp GFCI breaker was tripped in the control cabinet. I tried to reset it and it immediately...

Hello Everyone. We’ve got a BestWay FlowClear pump that was working perfectly until last week. I’m guessing the motor internals are deteriorating, which is causing the GFCI to pop ever so frequently. My question is: If the housing is in good condition, is it possible to replace just the motor...

So here's the FULL story... I was having issues with the electrical components (spotlight I installed above the pump as well as the pool light). Tried troubleshooting and fixing myself by replacing the fuses and whatnot. Called in an electrician and he fixed the issue. Go to turn on the pool...

Hello All. I sent this question to @ajw22 Hi I noticed you helped someone install a wi-fi switch in the past so I figured I would reach out. I have a 20 amp circuit breaker in my pool panel which runs to a GFCI outlet near by. So, hot, white into Line of GFCI Outlet. (naturally ground) Load...

Here's pics of what I got installed now. I'm looking to move the box about 1' to the side, and possibly 1' down so I don't have to pigtail new wires, and just keep the existing wires in tact. I'd like to cut the copper/emt tubes, and connect electrical PVC pipe w/ 90's to the new location. I'd...

I realize that this is a recurring story, but I haven't been able to resolve the issue. One of my SAm lights flooded in my pool (2 in pool, 1 in spa) causing all 3 lights to stop working. A typical problem for a 15 year old pool, according to other accounts on this forum. After letting the light...

I have a circa 2005 in ground pool with the Jandy Aqualink RS automation system that includes an 8 space sub panel. My pool guy recommended that I upgrade the breakers to GFCI for safety. I currently have two GFCI breakers - the pool light and the landscaping lights. The remaining breakers...

Hi. I’m baffled. The pool lights will not go on. I hear a click in the AquaLink box. The GFCI outlet connected to AquaLink RS doesn’t give electricity to either plug. I replaced it....same issues. Voltage tester showed power. But test button doesn’t work. There is a PX100...