Search results

ok. Thanks. I think I sort of needed affirmation with that? One other question... There is a 2 ft section after my pump but before my filter. I could T off there. Think it would be better than going into pump? i only have solar heating- so not worried about hurting anything. to me- that is bar...

Hello folks. Hope all is well! I need help on my stenner plumbing location... I have a pretty "wound" system because of my solar. So there are three valves that make decision on water flow when the solar is on. That said, I have found two locations after the filter that are "possible"...

I'm still jealous. Ha! spoke with my pops today who is a general contractor. He was like "dude... Add an extra breaker and just go direct to the relay to the outlet. Makes sense. Now just have to figure out how to inject this I to my system.

OK.. took your advice. I used the top load terminals and fed directly into the standard terminal with both the red and white. So now both red/white ports on the load side will be used. The pool light is then only relevant in its current setup (since it piggy backs of the GFI). Let me know...

OK. I think I have my diagram. Basically, I figured out I can't go from the pump because the GFI is plugged into its own breaker and I don't want to do an entire re-wire. I've reattached my current set-up below. SOOO... that leads me to this diagram. Basically, I am tethering off the pool...

This is extremely helpful... You aren't an artist though, huh? Kidding! It is perfect. It is very, very helpful. I am going to draw a diagram for my setup and run it by you. Would appreciate your thoughts on it. I am curious a bit why people cut the wires if they can do an outlet in their...

This is basically what my pool guy did to install the light - which makes a lot of sense. The pool light obviously has to be GFCI protected - except he used red. But I can see how he is using the GFCI downstream. Getting a similar setup for an additional plug sounds like a perfect plan. Here...

Based on everything I read, it seems that cutting the cord of the Stenner voids the warranty. Not ideal. The other issue is my EasyTouch is outside. I do have a GFCI plug on the side of the box - but again, from what I see here, by attaching that particular outlet to the timer relay load...

That would be so amazing. I found a thread that it seemed to be discussing similar topic as you but not exact... Pasted below. I do indeed have a free relay which should make it possible to do what you're doing. I'll be honest, electrical is not my strong suit but I've done my own after clearly...

I am so jealous AND so glad I came across this thread because I think you just volunteered to help me with many questions given our similar setups! I have been debating Liquidator vs Stenner for my entire pool ownership (13 months). I took control of my pool from the pool guy 2 months ago...