Search results

Search the forum Search WordPress Search MediaWiki
  1. T

    Intellichlor IC 40 Flow and Cell lights are off, Salt level lights flash red and green

    It blew the fuse in the power module. I ordered a new flow switch. I'll update when it gets installed. Thanks again to everyone for your help!
  2. T

    Intellichlor IC 40 Flow and Cell lights are off, Salt level lights flash red and green

    Thanks for the replies. I went out and looked at it this morning and I do not have a flow light, but I do have a green cell light that I did not have before and I have a green salt level light which I also did not have before. I had to increase the chlorine output to keep the cell light on. I...
  3. T

    Intellichlor IC 40 Flow and Cell lights are off, Salt level lights flash red and green

    I tried the bypass - connected red and black and no change. I ran the diagnostic and now the cold water light is red.
  4. T

    Intellichlor IC 40 Flow and Cell lights are off, Salt level lights flash red and green

    Salt is at 3200. Green is flashing as well.
  5. T

    Intellichlor IC 40 Flow and Cell lights are off, Salt level lights flash red and green

  6. T

    Intellichlor IC 40 Flow and Cell lights are off, Salt level lights flash red and green

    I had to compress to upload
  7. T

    Intellichlor IC 40 Flow and Cell lights are off, Salt level lights flash red and green

    02/12/2022 Rev 3200
  8. T

    Intellichlor IC 40 Flow and Cell lights are off, Salt level lights flash red and green

    it has 4,000 hours on it. It was given to me my a contractor when my ichlor 30 was leaking.
  9. T

    Intellichlor IC 40 Flow and Cell lights are off, Salt level lights flash red and green

    My flow is good and the water is 70 degrees. When I run the diagnostic test the cell light turns green and then goes off. Any ideas?
  10. T

    Filter causing a leak?

    You were right the check valve flapper gasket was leaking. Thanks for your help!
  11. T

    Filter causing a leak?

    I have a pool with a raised spa (approx. 8 ft diameter). My pool runs all day and is off at night. Every morning my spa drops between 2 and 3 inches of water. I have done several tests to try and isolate the problem. When I plug the spa returns and drain I do not lose any water in the SPA...
Top Bottom
Back