Search results

Search the forum Search WordPress Search MediaWiki
  1. A

    Vertical installation of CircuPool SJ-35 SWCG?

    I just installed CircuPool SJ-35 SWCG, with idea of running it nearly 24/7 using low RPM setting on my VS pump. Unfortunately, it requires at least 1500 RPM to keep air collecting at the top of SWCG, anything below and enough gas collects there for safety feature turning of generation due to...
  2. A

    PVC pressure relief valve?

    My current setup as built by pool builder has 3 way valve after filter: 1) goes through water temp sensor -> heater -> check valve -> (just installed) CircuPool SJ-30 SWG -> tablet chlorinator (not using for quite awhile) 2) is bypass for everything in #1 I also have suction-side Zodiac MX-6...
  3. A

    Sanding/flattening PebbleTec?

    I got a pretty bad finish on the floor of the pool (think of hand smudges in the plaster), and I wonder instead of trying to force the pool company to fix it, I perhaps could just sand it flat-ish somehow? Is it a good idea? Did someone do that? What could possibly take on the pebbletec, given...
  4. A

    Robotic cleaner for waterline, steps, benches, fake-infinity-edge recommendation? Or I am asking too much?

    I wonder if I am asking too much for a robot to clean. I know that cleaners in general have issues with steps/benches. And that fake-infinity-edge - I wonder if waterline can be cleaned there at all with any robotic cleaner? Any ideas, and especially experience, is greatly appreciated!
  5. A

    Possible air leak in the vac suction line?

    My pool has a dedicated vac port on the pool wall with 1.5" pipe going all the way to the equipment with a T VAC - vacuum line 1.5" SK - skimmer line 2" DR - bottom drain line - 2.5" I never had much luck with Zodiac MX6 pool cleaner running at the right speed off vac port without...
  6. A

    Hairline cracks on the outside wall

    Howdy! My pool has raised spa and the pool itself has partially exposed walls. I started noticing quite a few hairline cracks in the tile grout. On its own it would not raise much of concern, but later I noticed calcium buildup along these cracks. From my understanding the only way it would...
  7. A

    Concerned with a repair pool company did (potential cold joint?)

    My pool company did repair (raising i did not ask for, which is totally separate issue) and I am concerned about how it was done and potential of cold joint cracking and letting water outside of the shell. Anyone can share their thoughts about it? Should I be worried or not? I assume the same...
Top Bottom
Back