Search results

Hi Everyone, I just remodeled my pool, and we are having an issue. We installed 3 Pentair GloBrite color changing LED lights. They look amazing - at first all worked great. After about 1 week, when I clicked the switch, 2 of the 3 lights turn on simultaneously. Then, about 1 or 2 seconds go by...

Actually it depends if you have a saltwater pool vs. Chlorine. Hayward is better for saltwater...its internal parts are deigned to resist corrosion from saltwater. If chlorine then Raypak is slightly better but not worth paying an extra $200...if you can get the same btus with Raypak for under...

I have iAqualink. Works great. Yes went to heater and it was on Standby mode. Just needed to click the arrow on front panel of the heater to bring it out of standby...which is annoying because that has to be done physically at the heater...

It was in BO operation and working perfectly. Could be controlled by my phone with iaqualink. However, guests would mess with the heater to try to increase the heat, etc. So i had my pool guy put a cover over the panel so it couldnt be played with...worked great. Then, we had no guests for about...

Hi everyone. I have a new Hayward ng heater 400k btu. I also have pool automation through iAqualink. I set the temp to not heat for several days since it wasnt going to be in use. Today i turned on the mantain heat schedule. I checked the iAqualink app and saw that it was still on, but temp...

I guess i am asking if there is a benefit or reason to have a high rpm speed when priming. Or will having it too low break the pump or something?

Hi All. I have an intelliflo VS pump. I also have iAqualink pool controls. When the pump turns on, it first "primes" then it goes to whatever setting I have it on. I can set the RPMS for when it primes...right now it's set at 2350 rpms for priming. Is this good or can i set it lower? Basically...

Yes its a house. 4 bedroom. Rents 3 days to 5 days at a time but is booked all the time. Sometimes guests book for longer. In other words, heavy use

It actually is the opposite. It doesn't read temp at all until the pump turns on. When i turn on the pump, Then the temp will rise 3 to 5 degrees in a matter of minutes. Then if the pump is on for an hr or so, that's when i check and notice the temp is reading 90 or higher degrees.

Hi All, I have a newly installed IAqualink 2.0 system and i noticed a weird thing: i have it on a maintain heat setting (basically it samples the water every 3 hrs and if the temp is lower than what we set it at, the heater kicks on). The water temperature showing on the iAqualink app is all...

Thanks for the info. I thought i should get at least 1 (or close to it) water turnover per day? Its a vacation rental meaning it has tenants renting it and using the pool every day... but you think i should cut it to 5 hrs per day at 1000 rpm? Trying to optimize the electricity savings and keep...

Hi everyone, Does anyone know the lowest GPM needed for the Aqua Rite SWG to still work? I am trying to run my Intelliflo at the lowest possible RPM, outside of when heat is needed (which goes to 2350 rpm). Soon, the weather out here in the desert will require no heat source (other than the...