Search results

Unit it clicking, beeping, turning on and off. I turn the main power off and it works normally for about an hour then goes back to clicking, beeping, turning off and back on. Do I need a new motherboard or something?

Hi all, I have some tears in my filter grid. I saw the pleatco filters. My filter says 58 sqft does anyone know if that means the 60sqft filter will work? Thanks

Hi all, I have some tears in my filter grid. I saw the pleatco filters. My filter says 58 sqft does anyone know if that means the 60sqft filter will work? Thanks

Hi there, so my jandy is not turning off, heater runs on, will switch randomly to spa mode,. Code is 170 and beeping every 5 seconds. I cleaned cell, and sensors everything looked fine, no calcium build up and sensors looked okay. Any help is appreciated. Thanks

Hi all. So I vacuumed my pool today and all was normal. I turned off the pump and cleand the strainer. When I turned pump back on I had no prime. After searching I took cap of strainer and filled strainer and pipe with a hose, put lid back I and started pump water came out for 1-2 seconds then...

Hey all, drained washed pool and filter. Cleaned the seal and the housing applied lube tapped and tightened The clamp. Housing is leaking. New oring 6 months ago. Cleaned the filter before with no leaks. Any advice appreciated. Thanks

Draining my pool to repair and acid wash. Any advice or threads that will tell me what to do when once I refill. When to ad salt etc.. Thanks

Put in new new cell, wire,sensor. Been running for three days 2 hours on high, 6 hours on low speed. Says cell on, flow I have it set at 100 percent, tested today and my test strip was white which is zero. Any thoughts on what to do? Thanks

1. How do I pull up service error codes? Says no flow but doesn't show the error number. 2. When I did the front board test the part with the htemp and front button temp and chlorine no number appeared just -- two dashes. I put in a new sensor about a year ago. I don't know how old the cell is...