Search results

Are you absolutely sure both pumps are running?

San jaun pools of charlotte builds fiberglass. There are a number of quality gunite builders. Where are you located around the charlotte area?

Its small Enough to be a fill line? Not where I'd place it. However turn the system off and open the valve and see if you can hear water.

That's a pretty good life for a cell. What's your water temp? If you boost the system does the light come on?

Is there actually a spigot on there? I dont see one. Might be a gate valve? Can't tell from photo's. Id go ahead and get it changed out.

Throw the strips away and get a decent test kit. With calicum at 350 you have a greater risk of the plates building up. Scaletec should help in addition to checking cell every 3 months.

No danger to run fusion without vessel.

Where is the sensor placed in the system? Also, what are you getting for your air tempature?

Is the pump ever slow to Start? Maybe a humming from the motor? Any other devices on the breaker ot relay? (Heater, salt generator)

Be sure the backlight is set to turn on in the settings. If this is correct and no back light the PDA needs to be replaced.

Do you have flagstone around the pool?

Re: Infinity pool pump setup You should be able to shut on off without continuous water loss. Sounds like a check vAlve needs to be installed or repaired.

Few things to check. When you turn on the heater from your remote does a red light turn on at the controller at the "heater" button. And as asked earlier is "bo" enabled and a light beside pool or spa at the heater.

This! however keep in mind if its 34 outside it does not mean the system is reading 34.

Are you getting a water temp reading onthe PDA?

It really hasnt gotten cold enough (long enough) in the past few days for the freeze protect to come on with some systems. Im not very familiar with the tork systems. I do not think they have a sensor you can test in ice. Someone may have a little more info on these systems. I have a service...

Not quite sure why you have 2 ball valves there. Are you below water level? why the tee on the return side?

Great advice Boston that's what I have done on jobs like this. Another option is to use 2.5 coupling with a 2.5 x 2 bushing into th pump. A tee and 90s and go over the top of the check valve and skimmer/md valves. This would require more plumbing but an option if Boston's advice does not work.

What type and hp pump, what filter, and your changing a pressure switch in the heater? What type of heater.

No neds for indoor remote with aqualink. Pda kit comes with wireless remote. If you have all jandy equipment stick with it. I would not install a pentair automation system with all jandy equipment. You can tie your salt generator into the jandy system,full function of the lights. Plus the PDA...

If its a pool only and the pump ran dry you may have warped the male adapter coming into the pump. Can you take a few photos of your configuration? Are there any valves prior to the pump?

Are you running the pool and spa light on two relays or one? Would you be willing to run then together?

There are a few different options for jandys power centers. I see you already have a Aquapure Generator. You can do away with the box for that and run it off of the power center (if you want) As far as controlling the system would you prefer a wireless remote? A panel in the house? Or...

A shot in the dark. What kind of filter do you have? Is it in good working order?