Search results

Jtech1, you actually had my assumptions and interpretations correct. Apparently, I have read from a bad source that I could use a 2 pole breaker and run two separate 120 volt circuits off it. I also assumed that the total of my breakers could not equal greater than my disconnect breaker off 30...

I have answered my second question by simply googling. They do exist. As for my first question, do I go to the trouble of exchanging the breakers? Larry

I am currently installing a Jandy Sub Panel Power Center (http://www.poolsupplyworld.com/Jandy-66 ... 14AP-L.htm), and I will be putting my pump and one 120 volt light on it. They are currently (before the re-wire) plugged into a GFCI 20amp outdoor receptacle. First question: Since they will be...

Found it. Might want to save a copy, since it is in an old manual, and might disappear from the 'net. It is on page 9. http://www.poolinspections.com/manuals/ ... ooting.pdf Larry

Ok, thanks for letting me know.

Can you post a link or attachment to the wiring diagram for the 6796? Larry

You guys respond so quickly, that my questions are outdated! Thank you!

So.....If I understand everyone's replies correctly, I really don't need #3. What I need for heater/pump and (future) SWG, I need: 1. Jandy RS-P4 AquaLink RS OneTouch 2. Jandy 6613AP PureLink Standard Power Center OR 1. Jandy RS-P4 AquaLink RS OneTouch 2. Jandy 6613AP PureLink Standard Power...

Yes, I have Android, and love it! (I can control my indoor thermostat with it!) In the time that I posed the question earlier, I discovered the iAqualink. It appears I may not need the separate wired wall-mount controller, correct? I assume I still need the PureLink Power Center? This is all...

Hey, everyone! I think this is my first post here at TFP, but I've been lurking for quite some time, even before I registered. I'm not a pool rookie, but I'm a pool automation rookie. I have a 10K gal AGP. What I want to do is add a Jandy 125K heater this year, SWG NEXT YEAR, and automation...