Search results

Just to followup in case someone finds this later through Google, it wasn't the cell. I purchased a new APUREM controller, and a new PLC1400 cell and installed them both. Both of my existing cells worked fine with the new APUREM controller, so it was definitely something on the boards. As I...

This is the troubleshooting guide I'm using it's for an older system, but it's very simliar. https://images.inyopools.com/cloud/documents/jandy-aqua-pure-error-codes.pdf There's a flow-chart to diagnose problems, and all the test points, etc are clearly listed in terms of what the numbers...

Yes, I get 123 with one back board, and 124 with the other back board. It doesn't matter which cell I use, the errors report back the same. So... Back board A with Cell 1 - 123 Back board B with Cell 1 - 124 Back board A with Cell 2 - 123 Back board B with Cell 2 - 124 And yes, those are...

Yes, it does have an LCD - it's a 17 year old system at this point, but it still uses the same Jandy 1400 cell. Just an older setup on the boards themselves. Jandy Chlormatic III

Yes, the salt level is correct. It's reading the same on the temp/flow/salinity sensor as the reading I got when I took the water to have it tested at the local pool store. As far as the front-board, there simply aren't any available. I thought that might be the problem too, so I send it out to...

These are generic cells, each with their cable hard wired into the cell - it's not a bad cable. There have been two different cables used as they're directly attached to the cell. Also, I'm not using the jumper wire between the backboard, and the cell - the cell is directly plugged into the...

I've tried two different cells, both brand new. Unless I got two bad cells from the factory, that doesn't seem like it should be the problem.

I'm running into all kinds of issues trying to fix my SWG, and yes, I know it's old. It's the Jandy Aquapure/Chlormatic with the two boards, a front, and a back board. I've tested all the points on the back board, and got the following readings. 1-8 - 77.6 VAC ( manual says 75 ) 2-7 - 66.5...