Search results

Hello, I’m experiencing a similar problem with my Pentair light. Would you mind walking me through how you replaced the transformer? It sounds like you didn’t actually get behind the epoxy to the original transformer?

Thank you

Hello, I have a 120v Pentair Intellibrite light that stopped working. Initially we thought the control box was the issue because we had power going to the control but not out to the light. We replaced the control box and the lights worked for a minute or two then cut out again. We then replaced...

Thanks, I just ordered the Taylor k-2005

It is what I was told to use in order to increase CYA

Good morning, I have a question about low CYA levels. The past few days my CYA level has gone down below 20 ppm. I have added Bioguard super soluble to increase the CYA but it has had little to no effect on the levels. All my other levels are balanced (aside from slightly elevated FC from the...

Awesome thank you. That’s exactly what I am looking for.

Thank you

I’ve spent all morning looking for a return fitting that would restrict flow and I’m not finding what I’m looking for. Any suggestions?

My pool has a Polaris port that is now used as a return. I recently noticed that the flow/pressure coming out of the converted return is significantly higher than the other returns. Also, when I open the valve for the slide I can barely get any flow from the sprayers unless I fully open the...

Thanks for the reply. When in the water it doesn’t move forward or back at all. It just starts floating up on one side then drops back down and tries to start up again. I’m not sure how old the robot is unfortunately

I have a dolphin nautilus cc plus that was left with the pool from the previous owners. I have used it relentlessly that past two summers with only a few minor issues that eventually corrected themself. I use my vacuum daily but today when I put it in the water it would not move. I pulled it out...

Thank you for your input I appreciate it.

They put sealant between the blue stone as well but the blue stone is the only thing they actually locked down.

No they didn’t bond the tiles at all they just put the grout in and sealed the outer perimeter. They did put mortar down under the blue stone coping but that’s all.

They found hollow areas under the concrete in a few areas so they filled it in with concrete and put down a layer of crush and run between the concrete and the tiles.

Hi everyone, The concrete pool deck at our house had a lot of big cracks that were getting worse. So we had to different companies come out to see about repairing the concrete. We were told that our best option would be to put a tile overlay on top of the concrete. I had some major concerns...

I understand that however I know I have a tendency to knit pick and be a little over the top about things. Which is why I thought I would join this site and get honest opinions from people on here as this site has been a great resource since I became a pool owner.

Haha ok thank you.

Thank you

The slide is so old I have not been able to locate any information on it online.

This sticker on the slide identifies it as a SR Smith slide and I’m assuming it was originally installed in 2006. My husband and I purchased the house two years ago and the previous owners didn’t leave any info on the pool. We had it moved because it was unloading into 3 1/2 feet of water, which...

Thank you for your thoughts and info

I couldn’t get the escutcheon up on the leg with the dent but here is another leg

Thank you for the advice. Any thoughts on the overall safety of the slide?