Search results

My Mastertemp (1 1/2 years old) started acting up again. While heating the spa the heater kicked off around 88 degrees and gave me a Err HLS code. I did the research on that issue with help from past threads on this forum, thank you!! My High Limit Switch was functioning properly so I tested...

I have a one year old Mastertemp 400. It was working fine until last night when my wife went to heat the spa and the heater wouldn't work. It showed Err SFS and E06. I cut power off via the breaker hoping to reset the logic, but it still showed the errors. So, I turned power off via the...

I'm a first time pool owner and am wondering if I need to be concerned about cracking the heat exchanger in my Pentair Mastertemp 400. I have a leisure pools ultimate 35 with a built in spa. I am able to heat the spa separately, or pool, or both. My concerns center around the temperature...

I am pondering installing waterline tile to conceal large mortar joints on my coping. The coping hasn't been installed yet, but the fiberglass shell is "off level" enough that one corner will have an inch of mortar. The tile will cover this up the mortar joint and make the whole shell appear...

So, I am in the middle of a new pool install. My house was built 2 years ago and I had the builder install a standard 4 wire run to a sub panel for the future pool. Unfortunately I was off a bit on the location of the equipment pad and the sub panel had to be moved about 10ft. I hired the...

I resurrected this string since I am also worried about clearance issues with intellivalve actuators. I have all the pool equipment removed at the moment to pour a new concrete equipment pad, so if I need to redo the plumbing, now would be the time. Here is a current view of my valve...

My pool equipment is spread across three plastic pads which sit on gravel and are horribly off level and sitting below grade. This afternoon I will be disconnecting all my equipment to pour a new concrete pad under my equipment. Any suggestions on: water prep prior to disconnecting pumps and...

I am looking at upgrading to the Pentair Intellicenter and have done a lot of reading on this forum on the topic. My thanks to @MyAZPool for the excellent write up on the topic. I am still left with a couple questions. Here is my current situation: Fiberglass pool with spa (2) Pentair...

My Leisure Pool Ultimate 35 fiberglass pool install began 2 1/2 months ago. It has been a very unpleasant experience. IMO, Leisure Pools USA is a highly unethical company due to the way they market and detach themselves from any purchase of their product. That said, I still have a half...

My install has gone horribly awry. Does anyone have an installation manual or guidelines from Leisure Pools? I need this to view the manufacturer's specs on base material, fill, and level. My pool is off 1 1/2 inches over the 15 ft width, the installer claims it is within specs. They also...

Moved from here. Same exact pool and same problem. I am using a local installer vs factory, but finding this whole process maddening. I am a six weeks into a pool install that was supposed to happen 3 months ago and it isn’t even close to being finished. Going to make them fix it, but I am...