Search results

Oh nice. Well here is +1 feature vote for pool math.

How feasible would it be to calculate pool water volume with FAS-DPD or some other type of tetration method. With the known chlorine level and known dosage and then known final level could Poolmath calculate approximate pool volume?

This time around I have noticed very little plaster dust as compared to the first time. For comparisons, original replastered with blue dye, I had a lot of plaster dust, had to clean the DE 60 filter almost every other day and it would clog a lot. PH was very difficult to balance and pretty much...

Thank you so much for the insight. Very much appreciated.

My pool saga continues. Had the pool replastered in 2021, unfortunately that didn't end well and had to fight with the PB on getting it redone. Finally, last Monday, they came out to resurface the pool. Instead of Blue, as they didn't beleive they could do it right, they suggested just go with...

I have SureSoft Pool Salt at my Lowes and the ingredient list says 100% Sodium Chloride.

I'm itching to try this... https://www.amazon.com/NEWTRY-Turbidity-Turbidimeter-Compliant-Scattered/dp/B07V27TT3G/ref=sr_1_9?dchild=1&keywords=turbidimeter&qid=1633035389&sr=8-9&th=1

Signed out and signed back in, same account as the one I use to log into the forum. Still only showing todays logs…

So I upgrade from iPhone 12 Pro to the new shiner iPhone 13 Pro. iCloud sync is on backsups are enabled, I paid for Poolmath to have all the premium features. Switching to phones was pretty seemless. Poolmath carried over and no issues. Until this morning. Opened Poolmath and I’m greeted with a...

Thanks! We used Texas Lueders Limestone, instead of being the usual cream limestone it’s grey which is nice. Little harder then the usual limestone however I’m going to seal it shortly to give it some longevity. We been at it with the pool since Feb. it’s been pretty painful. Im just gathering...

Heater was bypassed. Made sure of it!

Pretty much how I feel.

So PB came on Friday, dumped 8 gallons of acid in the pool. gone from a white ish blue to dark blue…

Definitely actual leaves and a twig stuck in the plaster. They sending the plaster company out to take a look.

Few more… I need to stop looking, up to 7 now… uuuugh

Camera does a terrible job but they are just below the surface. One on the wall I was able to atleast brush what was sticking out but still…

The saga continues… so I have 5 leaves so far sticking out of the plaster.

Was going off the NPC guidelines for startup but it didn’t make sense. Thanks for the explanation.

So I think I have found a good route. 4 cups acid in the morning followed by 4 cups chlorine, then again, 12 hours later seems to keep things around 7.2-7.6 for PH and 2-3 for Chlorine. I checked CYA again and still not really registering, I got a 7 lbs pure CYA off amazon, and will put some in...

Is this considered install defect that the plaster company should redo or is this really you get what you get and there are zero guarantees and 100% of the risk of crappy install falls on the customer? At what point do you say, chip it out and redo. Just trying to get my expectations set...

Todays numbers, same as yesterday morning. PH above 8.0 TA 100 CH 220 Chlorine 0 again. Probably still getting consumed so will just keep adding… CYA, even after a gallon of instant condition it still registers less then 30. Used this…

Got the light going…. Sigh… lots of trowel lines and deep divets.