Search results

It appears to be. Those pages say nothing about this error message.

Has anyone familiar with Pentair IntelliCenter know what this err message means? See photo It also shows if I do solar preferred. Does not appear if I select Mastertemp400 heater, only solar

Is this the breaker that I want to use? Is the one I have now Eaton? this is Siemens and Dual pole (20 amp each like I have now) with GFCI and says it’s for spas etc i’ll have my electrician install it but I want to make sure I get the part and get it right.

OK so I deleted the single speed pump and left it as a aux generic feature. As I press the button for waterfall it goes on and off., seems to work fine . There is no control cable or RS485 to it. I disconnected the 485 cable then reset the variable speed pump to factory settings because I had...

OK so I will show you the screens on the IntelliCenter itself as well as screenshots of my phone. My phone seems to show communication. The last 2 are cell phone screenshots. You will also notice when the pump is running only the filter and namely not the booster pump for the Polaris or the...

Thank you I will make sure I get the right equipment

Tried 1725 and it was too slow. Noticeably better at 2000 I may go up just a little bit more, FYI.

OK lmk. Also I just added a 24 hour schedule for just the pool filter pump to run at low speed. Because it’s 24 hours it instantly activated and as of five minutes later still has that no communication error. So apparently I still have some kind of issue . I especially wanted to make sure it...

Yes, wear on the pebble surface. Thank you!

Thank you that’s helpful. I currently have pebble Tec at the latter part of it’s life so would a robot be any worse than my Polaris?

My pool is set up on schedules which I will attach. The majority are the big waterfall on the hour you can skip over probably. I will be making some modifications now that I have variable speed but this is what it is right now. I put it in pool mode by pushing the button on the touchscreen. I’m...

Update it took a few minutes but even with the cleaner on it now shows the correct information in the display. So does that mean it’s going to give me an air for a few minutes every time?

OK when I turned on the pool in auto mode it immediately showed the RPMs etc. and no error. Then for kicks I put it in spa mode and it updated the RPMs still no error. Then from spa when I pushed the Cleaner button the mode automatically switched to Pool mode, but now I got that error so I...

Also I have a zero depth pool entry so would a robot leave the pool? Or do you set up some kind of barrier like a robot vac?