Search results

Does it help to put bleach or anything else in the ledge lounger when filling it with water?

Our Mastertemp 400 heater was recently serviced. It was purchased about three years ago and put into service about 2.5 years ago, in Central TX. The bypass was broken, blocking water flow. The bypass, o rings, gasket and a new regulator were replaced. The tech noted that he saw corrosion on...

I've been adding stabilizer using a nylon stocking occasionally for the past 18 months. I started to do this today and the stocking fell apart. Are there recommended stockings that last longer or are folks replacing them every year or so?

I recently updated my Intellicenter firmware from 1.040 to 1.047 and then to 1.064. It's been awhile since I looked at my phone app, so timing may be a coincidence. Before the update, long before the update, I had this under Chemistry: Now my phone looks like this: My panel shows this...

Where the gauge screws into the top of the filter, there's a small leak. It looks like clear silicone was used to seal and it maybe just needs to be resealed, not sure. Does this sound right?

Planning to put a shed like this over my pool equipment. For venting the 400,000 BTU gas heater, it looks like we need to do this: https://www.manualslib.com/manual/841887/Pentair-Mastertemp.html?page=21#manual https://www.manualslib.com/manual/841887/Pentair-Mastertemp.html?page=22#manual...

We just noticed this today around the spa drain, it is black algae? Pool was filled 7/13, chemistry has been mostly good, had one green algae bloom about 10 days ago, slammed the pool and it went away in a couple of days. Added 400 lbs of salt a couple of days ago, haven't turned salt cell on...

Startup was 30 days ago. Chemistry has been good using weekly shock and muriatic acid. I think we're ready to add salt and install the salt cell. The salt cell is currently wired to our Pentair IC40 SCG control panel. Is it just a matter of putting the system in maintenance mode and swapping...

Started a new BYOP outside of Austin, TX in October 2020. Excavation in November, plumbing in December, gunite had a schedule delay, January, the ice storm threw us off schedule. Everything after the storm has been very slow. We're finally ready for plaster, hopefully next two weeks. The...

Hi All, We plan to start excavation next week. We're reviewing the builder proposed equipment list below, while reading the very helpful threads here on TFP. Pool will be 34' x 17' rectangle with 9' x 7' spa on the side. Two 12" sheers and a bubbler on the sun ledge. SWCG and Dolphin robot...

Moved from here.. Stenner Liquid Chlorine Chlorinator vs Salt Water Chlorine Generation This was discussed in another thread. I think it is appropriate here also. For a new pool build in Austin, TX area, we are thinking SWCG is a very good option. I read on another TFP thread that Lueder is...