Search results

I wouldn't do it. I'm sure the adhesive would damage the liner. Replacement liners are expensive. I've updated my experience with these lights... Post in thread 'Solar pool light' Solar pool light

Option to have the package forwarded to your home address for a small surcharge. Pick up locations are close by.

I use the Shippsy pick up point in Pickering ON. Very convenient.

I was able to find this on Amazon. It's called YoLink. Google it and you'll get the information you need... there's lot of it. I keep the sensor in a ziplock bag (not sure if I need too as it's weatherproof) and keep it under my skimmer lid. The probe is waterproof and the sensor is long...

Update on my Leduc Sun Solar Pool Lights: After 3 seasons both lights suffered failures. Water penetration under the epoxy coating on the solar panel part of the light caused bubbling and cracking, and now not able to charge. I did notice some small bubbles under the coating with one of my...

Ran my #'s on Monday night: FC - 4 CC - 0 pH - 7.6 TA - 70 CH - 50 CYA - 50 Didn't bother with salt yet as too cold to run, I still have the SWG place holder pipe installed. I take my cell out during the winter. I added bleach to bring up FC to 8. Question: Water looks good, #'s look...

Opened today. Pics taken right after cover was taken off. A couple weeks of cool.weather should give me plenty of time dial things in. Hopefully no snow in the forecast!!! . 🥶

I'm also located in Canada - 2hrs west of Ottawa. Reagents when stored properly last a while and I've been able to use my TF-Pro Salt kit for 3 seasons. Just purchased a refill kit during the 20% off sale last month. It's a bit pricey but so is a pool. I've yet to battle any water chemistry...

This happened to me and I found replacement "split nuts' that fit my Hayward T-Cell at my local pool store. Took 2 minutes to install and the cost for the part was $6. I bought a few extras to throw in my toolbox if the other one goes.

This is something I'm definitely going to add to my "Pool Toolbox'. Thanks for the info. 👍

I noticed while tinkering around my equipment pad that the fins on my heat pump were quite dirty. Reading up on the manual and it mentioned cleaning with a soft brush and water, but I was worried about bending the fins so I opted to use a garden hose on low pressure. Looks like new and...