Search results

It looks like the vent tube extends way past the intake and exhaust ports of the 2 heat exchangers. I'm going to get a flexible camera and check it out

Thank you. I looked further, and I don't know if water has come up enough to get in the heat exchanger. I will say that the drain tube that was hooked up to the bottom of the exhaust was buried as it was outside the heater and secondly, it was disconnected I was able to stick something up into...

Here are some Picrures

Blower does not fire. Nothing happens at all The hoses look fine. I shorted the blue wires to the AFS (jumped them) and nothing, ads light stays on and blowers don't fire. Maybe because blower doesn't kick in at all I'll recheck these, it's one of the first things I I did ----------- As I...

I am at wit end. I've had 2 Service People comment in the north metro Atlanta area to try and get my ETI400 heater working. Both of them when they showed up said they never worked on an ETI 400. Heater clicks on, fans don't even fire. No gas. silent. The red Light with AFS comes on. It's...

Spent this morning troubleshooting. Followed the serial cable from the panel to the pump closely, and there was some Significant fraying of the serial cable (looks Like a squirrel chewed it. )The outer insulation was chewed, and two of the wires were exposed. When I separated these immediately...

Hi Jim. With the panel in auto mode, the pump displays “pump address 1 DISPLAy not active. This was the first thing I checked right after you posted it. So it looks As if the the automation is talking to the Pump. If I put the panel into service mode, all relays (blower, lights, etc.) work...

Ok we are back, and I bypassed the wireless remote by hardwiring the ScreenLogic interface protocol adapter. I can “see” the panel now on ScreenLogic connect, but still cannot turn on any pumps, lights, etc. The main pump is saying “running schedule” but is not turning on. I can’t manually...

The screenlogic connect app on my computer recognizes the adapter on the network. The local systems IP address is 172.168.1.72:80 I did log in as the administrator. When I fire up the screen logic configuration screen, it just sits there are refreshes, like it cannot connect. No light changes...

Ok I’ve done a lot so far…. Attached are pics. ScreenLogic will not connect. I have the wireless protocol adapter, have tried the reset button 3 times, unplugged, moved it entirely to three different locations in the house. The wireless black laird link has a green light, but no link lit up...

OK so the pool pump ran this morning for about three or four hours. The n stopped. I can’t get it to restart. And it’s not a loose wire. Definitely think it has something to do with the antennae, com ports

Ok you guys are on the money….. The pumps both do display pumps not Active. Connection at pumps is clean, no corrosion. I followed the wire to the com antenna, and wiggled it (wire outside not at the com port), and immediately pump kicked on. Looks like a loose Connection. Will look at it...

Ok. Stopped Working again. Seems to have lost communication to the pumps. So when I reset The panel, all the lights seem normal, but if I push any of the buttons while In auto mode nothing works. If I put it in service mode, and push the pool pump button, the actuator Turns appropriately but...