Search results

Thought I would give everyone an update. I purchased a new Screenlogic setup (wireless) and it works fine. It must be something with the old firmware in the RF transmitter that did not work with the new Easytouch 8. Now onto installing the Chlorinator. Thanks!

Here you go. The one sticker fell off as I opened it.

Yes, it is communicating with the pump. I have 3 different speed settings programmed in the panel and it runs at all of them. I can go into the pump settings and see the status. I am not a 100% sure it is communicating with the SWG. I have the transformer and SWG board in the outdoor panel...

Yes, the remote is a P4HEASYTOUCH2A. I had some more time to test today. I removed all com wires except for the RF transmitter on the J20 port. Still did not connect to the remote. I put everything back to how it was; SWG board and Intelliflo on the J20 port and the antenna on comm port 2 of...

Ogdento, Thanks for the response. Hopefully below provides a little information on what I tried and experience with the panel so far. Yes, the wireless remote was working with the original easytouch 4 motherboard. Yes, I did the setting and wireless address on both the outdoor panel and the...

Hello, Long story short, I am having an issue reconnecting my Easytouch Wireless Remote back to the Easytouch 8 panel. Looking for some help or guidance. I have tried the menu -> settings -> "Wireless Address" routine with no luck. My main control panel came as Easytouch 8 chassis, but it...

Great, thank you for the quick reply. It will probably be capped this weekend.

Hello All, I am the 2nd owner of an in-ground pool/spa installed about 6 years ago. I wasn’t given too much information on the pool/spa from the previous owners. The pool is roughly 10,000 gallons and the spa is another 1,000 gallons. The main pump for the in-floor cleaning system also runs...