Search results

It's working! Problem was in the SW setup as suggested. In system setup no JVA was assigned, how that changed after 8 years of working just fine? Thanks so much for the help in narrowing down the problem, really appreciated!

ok, thanks for your help! I'll dig a bit further into the system.

Should be able to check the voltage, have a meter and basic knowledge. I'll see what I can figure out tonight - anything specific I should be looking for? (small switch on the actuator is working, toggles the valve open or closed, doesnt respond however to the Aqualink controller in the house...

Thanks for the input! Just double checked programming, all good. Can't make the valve move with the AquaLink - so my problem is either between AquaLink and the board or perhaps something to do with the sensor that also feeds into the system? Thanks again.

Noticed that my Jandy AquaLink no longer communicates with the Jandy valve that moves the solar on/off valve. The valve moves just fine if you use the switch on the valve, but doesn't respond with the controller inside the house or per the programed on/off times. Made sure wires are connected...