Search results

BTW I did read Matt's 29 page novel about his ordeal. I don't want to go down that rabbit hole. LOL

I have a dolphin s200 and when I bench test it upright (sitting on top of my test kit LOL so the tracks are off the ground), it acts like it should. Goes forward/impeller starts/diverter moves/impeller hits a couple more speeds/goes backward and then stops (I wanted to see the impeller and...

I did get it to prime by running a garden hose into the pump basket for a few minutes to "prime the lines". I'd say it is operating at about 85%. Should I just limp through the rest of the season or go ahead and pull the trigger and get a new one?

I have a very standard pool pump/motor/filter setup currently. (see photos and signature) I had to put new pump seals last year and they are leaking badly again already. The pump always has trouble priming (over a minute) so we just ran it 24/7. But now that the seal is leaking so bad, we...

This is 24 hrs after opening. Just a little cloudy This is the deep end (8ft) 48 hrs after opening. The bot doing it's job. I had to add a little water after backwashing (hence the garden hose)THANK YOU TFP!!!!!!!!!!!

Just want to thank TFP for making my pool maintenance so much easier and cheaper since I found this site. This is my pool 48 hours after it was opened!

Just got my s200. Thanks Margaret and TFP! I will try him out when I get home.

I'm on my 2nd season using TFP guidelines and you guys have saved me SO MUCH money and headaches over the past year and a half. This is my first post, but I've been "lurking" on the site for a while. My ancient Dolphin Diagnostic is dying and I am going to join the S200 club. I just became a...