Search results

Excellent - thank you so much

Here’s another

I am trying to figure out what replacement will work for my SWG. It says EPA REG # 69788-RI and underneath it says sanitizer cell 40. Doesnt say T CELL on it anywhere like others I have seen Getting mixed results on Google.

sorry, under the valve actuator on the bottom left side of the photo.

I did the pool sweep valve is bottom left

I tried that....the pool sweep was low pressure prior to this, so the guy adjusted something and now this issue started (although I put it back to the original position). Here's a picture

Thanks, I have tried (beginner here). Attached is a picture of the equipment.

Thank you, I tried that in the correct placement - no luck.

I had an issue with my pool sweep and someone came out and I believe played with the valves. Ever since, there seems to be a little bit of air under the pump lid. I switched the lids with my fountain filter and same issue.

I have a Hayward Pro Logic automation setup, and when I went out, the display was off. I ran through a few tests, thinking the display was faulty, but I've concluded that the main board is the issue. I found a couple of people online who repair Hayward boards, but I'm looking for...

Yes, tested to the power connection screw on the fuel. Heres a picture with the cover off - the screen loosk funky in the picture but its just glare, doesn't appear like that in person.

Yes, I just did. Confiming power is showing on the meter.

Picture attached.

I went out to manually turn on my pool filter and there is no power to the pro logic - checked the breaker and all is good. The pool heater has power. Any suggestions before I start making calls? Greatly appreciate it.

I have a Polaris 360 and it has not been moving fast in the pool. I did notice a leak in the hose and was curious if that was caused by a broken O-ring and if that would slow down the cleaner. I have attached a photo and any feedback would be greatly appreciated.

Hello, I had my water tested and I am confused on the salt reading. My system is reading the salt level as 2600PPM and needs salt and Leslies test reads 3847. I clean the salt generator, so not too sure what's going on. Here the following reading from Leslies (I know it's not as accurate as...

Looking for the best/most reasonable place to buy 4 new cartridges for my Hayward Smart Filter. Thanks in advance!

Thank you! It was a bad relay...