Search results

My Screenlogic connect does NOT show the Gas Heater. The heater can be activated from the EasyTouch panel. Pentair says they’re suppose to have an update to the App but I can’t see it. The service rep couldn’t see it either. Everything else works. Anyone has seen the same issue? Any word from...

I am going to upgrade the firmare of reference ........ never mind, it was a mistake

I did upgrade EasyTouch firmware following jerryt instructions above and it worked great. Jerry helped me at every step. Thanks a lot to him for the info provided.

Thank you! This is helpful.

OK. As I said, I will try this weekend. Thanks

right now I have a EasyTouch 4 and plan to get a EasyTouch 8

I will check if that's the case probably this weekend. I might take you on your offer if it doesn't work. In fact, I got to get a new board because the Valve portion in the current one is not getting power any longer. Where are you at? I sent you a PM last Friday, I will send you another one...

PE said so by this (http://www.pemicro.com/forums/forum.cfm?forum_topic_id=4413). The error was 20000021 error 45, I believe. I will try that. Thanks

The last version I could get on the Univ of Adelaide site is from 2004. PE says that it needs to be post 2010. I get a Error 45. I am using USB BDM MULTILINK, Rev C (PART# USB-ML-12). I appreciate your help. - - - Updated - - - One more thing. Could you be a little more specific about to...

Hi Jerrit, I am trying to update EasyTouch to the just posted 2.140. I got everything as you said but the programmer software that you pointed out to the Uni. of Adelaide, it is out of dat to use it with the Programmer. Is there a way to get it up to date? Thanks,