Search results

Like the title says my stay-rite system 3 D.E. Filter just cracked on the side.I assume I over tightened it. So, I guess it’s time for a new filter just not sure what type or brand to go with. Any information or opinions would be great. I was leaning towards a filter type but not sure yet.

I don’t presently have automation but I am considering it. I have a pentair vs pump system 3 D.E filter. And aquacal t135 heat pump my understating is the autopilot system works directly with it. I manually control 3way Valves when I want to use only the spa. I will post a picture after work.

Well as the title say I’m thinking about putting in a swg just not sure about my situation I have a spillover spa. I have concerns that if I’m operating in spa only mode that the f.c could get to high. Is this a concern that is justified or not a big deal.

I have a starite system 3. 37 square foot. I added 3.7 pounds immediately after back wash. No other chemicals have been added or floc. Not sure of the age of grids but they are intact. I have not soaked the in M.A. the only thing that happened is some leave got into the water and sat all winter...

F.c is 8.5 and holding without adding chlorine C.c is <.5 Cya is less then 20ppm. Filled the sight glass dot was crystal clear. water temp is 49 degrees It’s a tf test kit. A year old

I can’t seem to get my pool water clear I have slammed the water doesn’t look green but the water is still cloudy I ran the pump to recirculate and the f.c. level doesn’t drop .5 over night and c.c is less then .5 ph is 7.2. The problem is if I turn the pump on to filter. The grids seem to plug...

I don’t have an mpv bit I’m sure I can come up with a work around am just worried that even when my f.c. is stabilized I will still plug the filter.

So I started opening my pool this weekend raised the chlorine level and balanced the ph. Have a significant about of cloudiness the problem is I can only seem to run the filter for 2-3 hrs before it appears to be full and need to back wash. It’s a D.E. Flitter and it goes from 30psi. To 40psi...

So I have an old master pools 5 zone in floor cleaning valve that is leaking it’s a small leak but, annoying. It also made winterizing difficult because I couldn’t trap air in the pipes. So I would like to replace the valve body. My question is should I just buy replacement body or should I look...

It does not appear to by localized to shade only

So I am new to pool ownership. I have a 24k in ground pool. Have been using the BBB method since I opened the pool in April. The problem I'm having is I keep getting yellow is deposits on the plaster. But I'm not sure if it's alge. It brushes right off. I did an ONCT and only dropped 0.4 ppm...