Search results

Replaced Jandy VSP motor with non-VSP motor and now status says ePump offline and aquapure won't turn on. The pump is moving water fine but the aquapure won't turn on because it still thinks there is an ePump installed and that it is offline. I originally took out a non-VSP pump and installed...

My main question was Does the IQ900-RS board replace the 'Front Board'? (is front board the board that the tri sensor plugs into?) I just replaced this sensor mid July of 2014. I am now getting 172 and 186 errors, and immediately figured it was the board, since I just replaced the sensor. Now...

My spa led light went out about 6-7 months ago, I didn't mind it but now the pool light is out too. I can hear the relay clicking, the spa light is very very dim almost gray, and the pool light doesn't light up at all. I did some research and found that there is a 120V light for each, and a...

The idiots screwed the L brackets that hold the heater to the concrete pad, right through the casing and the heat echanger slid over during time, and put a pencil tip sized hole right in the heat exchanger!!! Company that installed wants $1800 to fix it. I had to ask them, even though I don't...

I have a 12,000 gallon in ground salt water pool with attached jacuzzi and three water features, all Jandy. I have two pumps, that I think are about 6 years old. They are PHPM 1.5's. One runs the water features, and the other the filter pump. The one that runs the water features got so loud I...