Search results

I was going to change my diverter after finally figuring out I was leaking water to my backwash, but then I notice a piece below the diverter appears to be broke. Do I need to replace the whole valve or will just replacing the diverter still work? Not sure what this piece is. Thanks

I disconnected my wires to my pool light a couple of years ago and filled the hole with expoxy. It is now leaking into my yard behind the junction box. My question is to permanently seal it, should I dig a hole behind the juction box to cap it or is the leak usally because the pipe is shattered...

I replaaced my motor. Is this good? I connected my old bracket that the screw broke off or do I need to place the actual wire underneath the screw?

I bought a new motor and was about to connect the impeller, but can't figure out how to hold the shaft in the back of the motor. How are you supposed to hold the shaft inplace?

I added stabilizer to the skimmer basket and then noticed my water level started to drop while the pool is running. It seem to get a little better over the next few days, but I waited like 72 hours and backwashed, then I really noticed the water level would drop. Any ideas would is appreciated.