Search results

See video here: The whine started in the past few weeks. It originally was just the pump primed/turned on - but has now become somewhat constant. This is a pretty annoying noise/can be heard by the pool and my neighbors so I'd like to address it. Any thoughts on how best to debug this/fix it?

My vision isn’t good enough, but the only thing I could imagine this is would be a pool fill line? It’s towards the water line at the shallow end of the pool. If so, why would it be closed/blocked off and where would it be controlled from? Thoughts?

I just migrated to the IC40 and have these to sell. Three pieces total: Hayward Aquarite controller Has the original Goldline control panel Underlying control board was replaced in May of this year Hayward T-Cell940 Salt Cell Was replaced in May of this year Hayward SWCG Flo Switch Was...

I've found that the reading from the built-in temp probe on the Mastertemp is fluctuating over time. Generally it reads as too low (water will be 80 deg and it reads at 66 deg). However, it's non-deterministic - sometimes it reads the temperature correctly. I've replaced it with a new Pentair...

I'm planning to replace my Hayward Aquarite system w/ T-cell 940 and putting in a Pentair Intellichlor 40. The current system is mounted upside down (see below), and is almost a perfect fit for the Intellichlor 40. Any issues with simply putting the Intellichlor in the same exact place mounted...

Hi all, My Pentair Intellitouch i5s seems to be acting up. Specifically: I noticed the automation didn't seem to be working anymore. When I looked at the App, it showed that there was a "System Delay" with "Pool Off Delay". I can't cancel the delay and/or perform any actions from the app or...